Viewing a Floor Plan

After the floor plan is configured, view it from a selected site's dashboard. The floor plan represents placed devices and associated badges that show configuration and performance data for the device. From the Floor Plans view, you can toggle between floors, filter data, and further fine-tune the map display.

To access Floor Plans view, go to Monitor > Sites, select a sight and select Floor Plans.

If one or more floor plans exist, available floor plans display in the right-side pane.

Here are a few things you can do with a floor plan:

To search for devices:
- Select the search icon .
- Select on the search field and select device from the drop-down list.
To zoom in and out, do one of the following:
- Select to zoom in.
- Select to zoom out.
- Double-click on the map to zoom in. Use the mouse scroll wheel to zoom out.
- Select the map and use the mouse scroll wheel to zoom in and out.

Check device status:

Table 1. Device Status from the Floor Plans View
Status	Description
	AP is in-service, operating.
	In-service, trouble.
	Critical. Indicates that ExtremeCloud IQ Controller cannot communicate with the AP.
	Unknown. AP is unknown to the displayed floor plan based on floor plan filter settings. Typically occurs when the device group for the AP is not selected.
	Unknown. The AP serial number is unknown to the floor plan. Typically occurs when you import a floor plan with AP place holders. For more information, see Use Case: Importing A Floor Plan with Unknown APs.
	Sensor device
	Switch
	Camera AP displayed as circular icon.
	Extreme Defender Adapter
	Ceiling-Mounted AP
	Wall-Mounted AP

Use Auto Refresh to automatically refresh the information presented. From the Auto Refresh drop-down field, select the refresh value. Valid values are:

OFF
30 Seconds
1 Minute
3 Minutes
5 Minutes

You can also select

to manually refresh the page anytime.

Note

Save your page setting changes. Auto Refresh is implemented at the browser level and therefore will reset any selections or unsaved page setting changes. When using Auto Refresh, select a refresh interval that allows you to complete the operation within the defined interval. For best results, set Auto Refresh to OFF during configuration selections or selection of a large number of elements.

Both Associated and Unassociated clients are refreshed, provided they are marked as showing on the Positioning dialog. For more information, see Positioning Heatmaps.