Configure Wired Interfaces Settings

Table 1. Wired Interfaces Settings
Field	Description
Interface	The software representation of the physical port.
State	Indicates if the port is enabled or disabled.
Port Type	The interface port type. This field is read only.
Native VLAN	The native (untagged) VLAN assigned to frames that do not have any 802.1Q VLAN tags in their headers.
Allowed VLANs	The VLANs, including the native VLAN, that you want the trunk port to permit. You can list the VLANs individually, separated by commas, or as a range of VLANs using a hyphen. Alternatively, you can enter the word all in this field to support all existing VLANs previously configured in the network policy (the default).
Fabric Attach	Select , and then enter a Name and Description for the Fabric Attach. For each VLAN, select , and then enter the device's associated VLAN ID and I-SID. Select a VLAN from the list, and then select to remove the VLAN from the Fabric Attach. Select Save.
Transmission Type	Select one of the following options: Auto: The switch negotiates the best common duplex mode with the connected device. Full-Duplex: Forces the switch to communicate with the connected device using full duplex communication. Half-Duplex: Forces the switch to use half duplex communication.
Speed	The speed the Ethernet port uses to communicate with the connected device.
LLDP	Select for devices to advertise identities, status, and capabilities to each other. Devices can transmit data about themselves and receive transmitted data from other devices, but they cannot solicit and retrieve data from other devices.
CDP	Select for devices to advertise an IP address that can send and receive SNMP traps.
MCast Filter	Select to enable Multicast Rate Limiting on the interface for multicast/ broadcast traffic.
Multicast Rate Limit	Set the maximum rate (in Kbs) for incoming multicast traffic for the interface.