uninstall image
On a SummitStack, use:
uninstall image fname partition {slot slot number } {reboot}Description
Uninstalls an ExtremeXOS software package.
Syntax Description
fname | Specifies the software package to uninstall. |
partition | Specifies which partition the package was installed to: primary or secondary. Select primary to remove it from the primary partition and secondary to remove it from the secondary partition. |
slotid | Specifies the MSM where the
package should be uninstalled:
Note: This parameter is available only on modular switches and
SummitStack.
On a SummitStack, the slot number specifies
the node on which the BootROM image should be uninstalled. |
reboot | Reboots the switch after the package is uninstalled. |
Default
N/A.
Usage Guidelines
Use this command to uninstall a software package previously installed on the switch.
When you uninstall a software package, the switch prompts you to save your changes to your currently active configuration file:
Uninstallation of the EXOS module Do you want to save configuration changes to primary.cfg? (y or n)
Enter y to save the changes to your configuration file. Enter n to not save the changes to your configuration file.
Local Filename Character Restrictions
This section provides information about the characters supported by the switch for local and remote filenames.
When specifying a local filename, the switch permits only the following characters:
- Alphabetical letters, upper case and lower case (A-Z, a-z)
- Numerals (0-9)
- Period ( . )
- Dash ( - )
- Underscore ( _ )
When naming a local file, remember the requirements previously described.
SummitStack Only
You can issue this command only from a Master node.
Example
uninstall image *switch-ntp.xmod secondary
History
This command was first available in ExtremeXOS 11.0.
The msm parameter was added in ExtremeXOS 11.1.
The slot parameter was added to support SummitStack in ExtremeXOS 12.0.
Platform Availability
This command is available on all platforms.