channelize

Syntax

• channelize enable

• channelize port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

• default channelize enable

• default channelize port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

• no channelize enable

• no channelize port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} enable

Command Parameters

enable

Enable channelization for all ports.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

By default, ports are not channelized, which means that a port operates as one single port at the fully supported speed. The switch automatically channelizes a port if the port operates in Auto-sense mode and you insert one of the following:

• QSFP+ to SFP+ adapter

• QSFP28 to SFP28 adapter

• QSFP+ to 2xSFP+ passive or active breakout cable

• QSFP28 to 4xSFP28 passive or active breakout cable

Command Mode

GigabitEthernet Interface Configuration

Usage Guidelines

Not all hardware platforms support channelization. For information about hardware support, see your hardware documentation.

To disable automatic channelization on a port, you must disable Auto-sense on the port.