speed

Syntax

• default speed [port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}]

• speed [port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}] <10 | 100 | 1000 | 10000 | 2500 | 25000 | 5000>

Command Parameters

<10|100|1000|10000|2500|25000|5000>

Specifies the port speed.

{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

None

Command Mode

GigabitEthernet Interface Configuration

Usage Guidelines

You cannot use this command on VIMs that support the sys vim-speed or sys vim-speed groupcommands.