eapol max-request

Syntax

• default eapol max-request

• default eapol port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} max-request

• eapol max-request <1-10>

• eapol port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} max-request <1-10>

Command Parameters

<1-10>

Specifies the maximum EAP requests sent to supplicant before timing out the session.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default is 2.

Command Mode

GigabitEthernet Interface Configuration