Display Port VLAN Information
Procedure
Example
Switch:1>enable Switch:1#show interfaces gigabitethernet vlan ==================================================================================================== Port Vlans ==================================================================================================== PORT DISCARD DISCARD DEFAULT VLAN PORT UNTAG DYNAMIC UNTAG FA/ NUM TAGGING TAGFRAM UNTAGFRAM VLANID IDS TYPE DEFVLAN VLANS VLANS Flex UNI ---------------------------------------------------------------------------------------------------- 1/1 disable false false 1 1 normal disable P 1 disable 1/2 enable false false 1 1,3,10 normal disable P 1,10 disable 1/3 enable false false 1 1,10,20 normal disable P disable ---------------------------------------------------------------------------------------------------- DYNAMIC VLAN Legend: P=Protocol enabled.
Variable Definitions
The following table defines parameters for the show interfaces command.
Variable |
Value |
---|---|
{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} |
Identifies the
slot and port in one of the following formats:
|
<1-4059> |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |