Configure Multi-area SPB Layer 2 I-SID List

About this task

Perform this procedure to configure the Multi-area SPB layer 2 I-SID list.

Procedure

  1. Enter IS-IS Router Configuration mode:

    enable

    configure terminal

    router isis

  2. Configure the Multi-area SPB layer 2 I-SID list:

    multi-area l2 isid-list WORD<1-32> WORD<1-1024>

Example

Configuring the Multi-area SPB layer 2 I-SID list that includes specific I-SID values:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#router isis
Switch:1(config-isis)#multi-area l2 isid-list testlist 1,3,5,100-200

What to do next

To verify the configuration, see Display IS-IS Multi-area SPB Layer 2 I-SID List Information.

Variable Definitions

The following table defines parameters for the multi-area l2 isid-list command.

Variable Value
WORD<1-32>

Specifies the name of the I-SID list.

WORD<1-1024>

Specifies the list of I-SID values.