Variable Definitions

The following table defines parameters for the ip spb-multicast-policy command.

Variable

Value

apply

Applies the IP SPB Multicast Policy on route-map.

enable

Enables the IP SPB Multicast Policy on route-map.

route-map WORD<0-64>

Specifies the route of the policy.

WORD<0-64> specifies the name of the policy.

vrf WORD<1-16>

Specifies the VRF name.

The following table defines parameters for the match command.

Variable

Value

multicast-groupWORD<0-259>

Specifies the multicast group for IP SPB Multicast Policy .

WORD<0-259> specifies the name of one or more prefix lists, separated by a comma.

The following table defines parameters for the set command.

Variable

Value

data-isid <1-15999999>

Specifies the data services instance identifier (I-SID) for static I-SID routed multicast policy.

rx-only

Specifies the received traffic only, applicable to static I-SID routed multicast policy.

tx-only

Specifies the transmitted traffic only, applicable to static I-SID routed multicast policy.