Configure the Web Management Interface

Before you begin

Enable the web server.

About this task

Configure the web management interface to change the user names and passwords for management access to the switch using a web browser.

HTTP, FTP, and TFTP server supports both IPv4 and IPv6 addresses, with no difference in functionality or configuration.

You can also use the CLI interface for creating users.

Procedure

In the navigation pane, expand Configuration > Security > Control Path.
Select General.
Select the Web tab.
Complete WebRWAUserName and WebRWAUserPassword to specify the user name and password for access to the web interface.

This user will have full permission.
To enable the RO user for the web server, select WebROEnable.
Complete WebROUserName and WebROUserPassword to specify the user name and password for access to the web interface.

This user will have read only permission.
Select Apply.

Web Field Descriptions

Use the data in the following table to use the Web tab.


Name	Description
WebRWAUserName	Specifies the RWA user name. The default is admin.
WebRWAUserPassword	Specifies the password for the RWA user account. The default is password.
WebROEnable	Enables the web server read-only (RO) user, which is disabled by default.
WebEncryptionType	Specifies the ciphers for preset version of TLS for the web server.
WebCertSubjectName	Specifies the digital certificate subject Name used as identity certificate in the web server.
WebCertCAName	Specifies the digital certificate CA trustpoint name used for the certificate in the web server.
WebROUserName	Specifies the RO user name. The default is user.
WebROUserPassword	Specifies the password for the RO user account. The default is 12345678.
MinimumPasswordLength	Configures the minimum password length. By default, the minimum password length is 8 characters.
HttpPort	Specifies the HTTP port for web access. The default value is 80.
HttpsPort	Specifies the HTTPS port for web access. The default value is 443.
SecureOnly	Controls whether the secure-only option is enabled. The default is enabled.
InactivityTimeout	Specifies the idle time (in seconds) to wait before the EDM login session expires. The default value is 900 seconds (15 minutes).
TlsMinimumVersion	Configures the minimum version of the TLS protocol supported by the web-server. You can select from the following options: tlsv10 – Configures the version to TLS 1.0. tlsv11 – Configures the version to TLS 1.1. tlsv12 – Configures the version to TLS 1.2 The default is tlsv12.
SSLRenegotiation	Specifies whether SSL renegotiation is enabled or disabled. The default is enabled.
HelpTftp/Ftp_SourceDir	Configures the TFTP or FTP directory for Help files, in one of the following formats: a.b.c.d:/\| peer:/ [<dir>]. The path can use 0–256 characters. The following example paths illustrate the correct format: 192.0.2.1:/Help 192.0.2.1:/
DefaultDisplayRows	Configures the number of rows each page displays. The default is 30.
LastChange	Shows the last web-browser initiated configuration change.
NumHits	Shows the number of hits to the web server.
NumAccessChecks	Shows the number of access checks performed by the web server.
NumAccessBlocks	Shows the number of access attempts blocked by the web server.
LastHostAccessBlockedAddressType	Shows the address type, either IPv4 or IPv6, of the last host access blocked by the web server.
LastHostAccessBlockedAddress	Shows the IP address of the last host access blocked by the web server.
NumRxErrors	Shows the number of receive errors the web server encounters.
NumTxErrors	Shows the number of transmit errors the web server encounters.
NumSetRequest	Shows the number of set-requests sent to the web server.