Configure Static Forwarding
Configure static forwarding to specify the group of ports that are allowed to forward frames.
Important
Entries are valid for unicast and for group/broadcast addresses.
Procedure
- In the navigation pane, expand .
- Select VLANs.
- Select the Basic tab.
- Select a VLAN.
- Select Bridge.
- Select the Static tab.
- Select Insert.
- In MacAddress, type a forwarding destination MAC address.
- In Port, select the ellipsis (...).
- Select the port on which the frame is received.
- Select Ok.
- Select Insert.
Static Field Descriptions
Use the data in the following table to use the Static tab.
|
Name |
Description |
|---|---|
|
MacAddress |
Specifies the destination MAC address in a frame to which the forwarding information for this entry applies. This object can take the value of a unicast address. |
|
Port |
Specifies the port number of the port on which the frame is received. |
|
VlanId |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |
|
Status |
Specifies the status of the VLAN. |