Configure an IPv6 RIPng Brouter Port Interface
Configure RIPng parameters on an interface so you can control RIPng behavior on the interface.
Before you begin
-
Configure a routing interface (either a brouter port or a virtual routing interface).
-
Assign an IP address to the interface.
-
Enable RIPng globally and on the interface.
About this task
RIPng does not operate on an interface until you enable it globally and on the interface.
Procedure
- In the Device Physical View, select a port.
- In the navigation pane, expand Configuration >EditPort.
- Select IPv6.
- Select the RIPng tab.
- In RipAdminStatus, select enable.
- Configure other parameters as required.
- Select Apply.
RIPng Field Descriptions
Use the data in the following table to use the RIPng tab.
Name | Description |
---|---|
RipAdminStatus |
Enable or disable RIPng on an interface. |
DefaultInfoState |
Enable or disable default information at the interface level. The default is disable. |
Cost |
Specifies the RIPng metric cost. The default is 1. |
Poison |
Enable or disable poison reverse on an RIPng interface. The default is disable. |
RipOperStatus |
Shows the RIPng operational state on an interface. |