Specify the VRF for Auto-sense ExtremeCloud SD-WAN Configuration

Before you begin

On switches that support only a single active VRF, ensure a user-defined VRF with a different name does not exist.

About this task

Perform this procedure to specify the VRF that Auto-sense uses for the SD-WAN configuration. On models that support a single active VRF, Auto-sense cannot create the dynamic SD-WAN VRF if an IP configuration already exists.

Note

Note

If the running switch configuration includes the dynamic SD-WAN VRF and you complete this procedure, the switch renames the dynamic VRF to your specified name, and converts the configuration to static.

Procedure

  1. In the navigation pane, expand Configuration > Fabric.
  2. Select AutoSense.
  3. Select the SD-WAN tab.
  4. In SD-WAN VRF, type the name of the VRF.
  5. Select Apply.

SD-WAN Field Descriptions

Use the data in the following table to use the SD-WAN tab.

Name Description
SD-WAN Area
Note: This field only displays on a switch with boundary-node abilities.

Specifies the IS-IS area, home or remote, where Auto-sense creates all ExtremeCloud SD-WAN learned tunnels. By default, Auto-sense creates SD-WAN logical interfaces in the home area.

You can also configure exceptions for specific tunnels. For more information, see Configure the IS-IS Area for a Specific Tunnel.

Sd-Wan Vrf

Specifies the VRF name that Auto-sense uses for the SD-WAN configuration. On models that support a single active VRF, Auto-sense cannot create the dynamic SD-WAN VRF if an IP configuration already exists.