Configure IPv6 PIM on a Port or VLAN

Configure PIM for each interface to enable the interface to perform multicasting operations.

Before you begin

  • Enable IPv6 interface.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Create a PIM interface on a port or VLAN:

    ipv6 pim enable

    This command creates an active interface, by default.

  3. Configure the interval for join and prune messages:

    ipv6 pim join-prune-interval <1–18724>

  4. Configure the time between hello messages:

    ipv6 pim hello-interval <0–18724>

Example

Switch:1(config-if)#ipv6 pim join-prune-interval 60
Switch:1(config-if)#ipv6 pim hello-interval 30

Variable Definitions

The following table describes the variables for the ipv6 pim command.

Variable

Value

hello-interval <0-18724>

Specifies the duration in seconds before the PIM router sends out the next hello message to neighboring switches.

The default value is 30 seconds.

join-prune-interval <1-18724>

Specifies the duration in seconds before the PIM router sends out the next join or prune message to its upstream neighbors.

The default value is 60 seconds.