Delete a Dynamically-Learned Route

Use the Routes tab to view and manage the contents of the system routing table. You can also delete a dynamically learned route using this table. Exercise caution if you delete entries from the route table.

Before you begin

To perform this procedure on a non-default VRF, you must first change the VRF instance. For information about how to use EDM for a non-default VRF, see Select and Launch a VRF Context View. All parameters might not be available in non-default VRFs.

About this task

To delete a static route, use the StaticRoute tab.

Procedure

In the navigation pane, expand Configuration > IP.
Select IP.
Select the Routes tab.
To delete a route, select the route, and then select Delete.

Routes Field Descriptions

Use the data in the following table to use the Routes tab.


Name	Description
Dest	Specifies the destination IP network of this route. An entry with a value of 0.0.0.0 is a default route. The system can display multiple routes to a single destination in the table, but access to multiple entries depends on the table access mechanisms defined by the network management protocol in use.
Mask	Indicates the network mask to logically add with the destination address before comparison to the destination IP network.
NextHop	Specifies the IP address of the next hop of this route.
AltSequence	Indicates the alternative route sequence. The value of 0 denotes the best route.
NextHopId	Specifies the identifier of the next-hop, hostname or MAC address.
HopOrMetric	Specifies the primary routing metric for this route. The semantics of this metric are specific to various routing protocols.
Interface	Specifies the router interface for this route. Virtual router interfaces are identified by the VLAN number of the VLAN followed by the (VLAN) designation. Brouter interfaces are identified by the slot and port number of the brouter port.
Proto	Specifies the routing mechanism through which this route was learned: local—nonprotocol information, for example, manually configured entries static isis inter-vrf redistributed route
Age	Specifies the number of seconds since this route was last updated or otherwise determined correct.
PathType	Indicates the route type, which is a combination of direct, indirect, best, alternative, and ECMP paths. iA indicates Indirect Alternative route without an ECMP path iAE indicates Indirect Alternative ECMP path iB indicates Indirect Best route without ECMP path iBE indicates Indirect Best ECMP path dB indicates Direct Best route iAN indicates Indirect Alternative route not in hardware iAEN indicates Indirect Alternative ECMP route not in hardware iBN indicates Indirect Best route not in hardware iBEN indicates Indirect Best ECMP route not in hardware dBN indicates Direct Best route not in hardware iAU indicates Indirect Alternative Route Unresolved iAEU indicates Indirect Alternative ECMP Unresolved iBU indicates Indirect Best Route Unresolved iBEU indicates Indirect Best ECMP Unresolved dBU indicates Direct Best Route Unresolved iBF indicates Indirect Best route replaced by FTN iBEF indicates Indirect Best ECMP route replaced by FTN iBV indicates Indirect best IPVPN route iBEV indicates Indirect best ECMP IP VPN route iBVN indicates Indirect best IP VPN route not in hardware iBEVN indicates Indirect best ECMP IP VPN route not in hardware
Pref	Specifies the preference.
NextHopVrfId	Specifies the VRF ID of the next-hop address.