Configure a Auto-sense Global Data I-SID

Before you begin

  • Enable Auto-sense on the port.

  • Associate a VLAN with the I-SID before you configure it as the global data I-SID.

About this task

Perform this task to configure Auto-sense data traffic information for ports that are operating in Auto-sense mode.

Note

Note

This option applies to the auto-sense UNI and voice states only, it replaces the onboarding I-SID and places an (untagged) client device into a pre-defined global data I-SID.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Configure the data service instance identifier (I-SID):

    auto-sense data i-sid <1-15999999>

Example

Configuring the Auto-sense data I-SID:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#auto-sense data i-sid 1000

Variable Definitions

The following table defines parameters for the auto-sense data command.

Variable

Value

i-sid <1-15999999>

Specifies the service instance identifier (I-SID).