Enable or disable FA Zero Touch Client Attachment

Use this procedure to enable or disable the global FA Zero Touch Client Attachment feature on an FA Proxy or Server. By default, FA Zero Touch Client Attachment support is enabled.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Enable an FA Zero Touch client:

fa zero-touch-client standard <camera|phone|router|security-device|srvr-endpt|switch|video|virtual-switch|wap-type1|wap-type2> i-sid <1–15999999>
Disable an FA Zero Touch client:

no fa zero-touch-client standard <camera|phone|router|security-device|srvr-endpt|switch|video|virtual-switch|wap-type1|wap-type2>

Example

Switch:1(config)# fa zero-touch-client standard camera i-sid 1003

Switch:1(config)# no fa zero-touch-client standard camera

Variable definitions

The following table defines parameters for the fa zero-touch-client standard command.


Variable	Value
camera	Specify element type to match camera.
phone	Specify element type to match phone.
router	Specify element type to match router.
security-device	Specify element type to match security-device.
srvr-endpt	Specify element type to match srvr-endpt.
switch	Specify element type to match switch.
video	Specify element type to match video.
virtual-switch	Specify element type to match virtual-switch.
wap-type1	Specify element type to match wap-type1.
wap-type2	Specify element type to match wap-type2.