Install and Uninstall Licenses on Universal Switches

Obtain and Install a License

For universal hardware switches, you can activate a license on the switch using either of the following methods:

• Manual activation by obtaining the license activation file from the Extreme Networks Support portal.

• Automated activation using ExtremeCloud IQ. For information about using ExtremeCloud IQ for bulk automated license activation, go to https://www.extremenetworks.com/support/documentation/extremecloud-iq.

To obtain and install a license, follow these steps:

Note

You should have received by email a license voucher after your purchase of a switch. You will need the voucher ID number on this email to generate a license.

For manual license generation and installation:

1. Upgrade the switch so that it is running the most recent GA version of the software.

   To download the latest GA software, visit the Extreme Networks Support portal.

2. Follow manual activation instructions for license generation available on the Extreme Networks Support portal: Products > ExtremeSwitching > Universal > Fabric Engine (VOSS) (for your switch) > Activation Instructions.

3. Download the license file onto the switch.
4. Install the license, using the command load-license license_filename.

The software verifies the license and activates the features that correspond to the license category.

For more information, see either of the following:

• License Installation using CLI

• License Installation using EDM

Transfer a License

You can permanently remove a license, which allows you to transfer the license to another switch. This should only be done when preparing to return a defective switch for a replacement switch (RMA).

For more information, see either of the following:

• Revoke a License (using CLI)

• Revoke a License (using EDM)