Configure SCI Tagging for a MACsec Enabled Switch

About this task

Use the following procedure to configure SCI tagging on a MACsec-enabled switch. The default is disabled.

If you are running VOSS 8.4.2 or earlier, disable SCI tagging on the switch.

Procedure

  1. Enter mka profile Configuration mode:

    enable

    configure terminal

    macsec mka profile WORD<1-16>

  2. Enable SCI tagging on the switch:

    include-sci enable

    Note

    Note

    The configuration should be the same at both ends of the link, either enabled or disabled.