Variable Definitions

The following table defines parameters for the show ip igmp interface command.


Variable	Value
gigabitethernet `{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}`	Identifies the slot and port in one of the following formats: a single slot and port (slot/port) a range of slots and ports (slot/port-slot/port) a series of slots and ports (slot/port,slot/port,slot/port) all ports on the same slot (slot/all) all ports on the switch (all) If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
vlan `<1-4059>`	Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
vrf `WORD<1–16>`	Specifies the VRF by name.
vrfids `WORD<0–512>`	Specifies the VRF by VRF ID.

The following table defines parameters for the show ip igmp cache command.


Variable	Value
vrf `WORD<1–16>`	Specifies the VRF by name.
vrfids `WORD<0–512>`	Specifies the VRF by VRF ID.

The following table defines parameters for the show ip igmp group command.


Variable	Value
count	Specifies the number of entries.
group `{A.B.C.D}`	Specifies the group address.
member-subnet `{A.B.C.D/X}`	Specifies the IP address and network mask.
vrf `WORD<1–16>`	Displays the multicast route configuration for a particular VRF by name.
vrfids `WORD<0–512>`	Displays the multicast route configuration for a particular VRF by VRF ID.

The following table defines parameters for the show ip igmp sender command.


Variable	Value
count	Specifies the number of entries.
group `{A.B.C.D}`	Specifies the group address.
member-subnet `{A.B.C.D/X}`	Specifies the IP address and network mask.
vrf `WORD<1–16>`	Displays the multicast route configuration for a particular VRF by name.
vrfids `WORD<0–512>`	Displays the multicast route configuration for a particular VRF by VRF ID.