Display the SPBM Multicast Database
You can determine the database used by the SPBM multicast module by using the following procedure.
Procedure
- Show the SPBM multicast
database:
show isis spbm ip-multicast-route [all][detail][group {A.B.C.D}][vlan <2–4059>][vrf WORD<0–16>][vsn-isid <1–16777215>]
Important
When you use this command without parameters or use the detail or group optional parameters without specifying a VLAN ID or VSN I-SID, the command output displays Layer 3 context only. No Layer 2 context is displayed.
Example
Show the SPBM multicast database:
Switch(config)#show isis spbm ip-multicast-route
================================================================================
SPBM IP-MULTICAST FIB ENTRY INFO
================================================================================
Source Group Data ISID BVLAN Source-BEB
--------------------------------------------------------------------------------
192.2.0.1 233.252.0.246 16000001 101 EVP
--------------------------------------------------------------------------------
Total Number of SPBM IP MULTICAST ROUTE Entries: 1
--------------------------------------------------------------------------------
Variable Definitions
The following table defines parameters for the show isis spbm ip-multicast-route command.
|
Variable |
Value |
|---|---|
|
all |
Displays all IP Multicast over Fabric Connect route information. |
|
detail |
Displays detailed IP Multicast over Fabric Connect route information. |
|
group {A.B.C.D} source {A.B.C.D} |
Displays information on the group IP address for the IP Multicast over Fabric Connect route. If you select source it will also display the source IP address. |
|
vlan <2–4059> |
Displays IP Multicast over Fabric Connect route information by VLAN. |
|
vrf WORD<0–16> |
Displays IP Multicast over Fabric Connect route information by VRF. |
|
vsn-isid <1–16777215> |
Displays IP Multicast over Fabric Connect route information by I-SID. |