Enable Fast PoE on a Port

About this task

Perform this procedure to enable Fast PoE on a specific copper port of the switch. After you enable Fast PoE, you must save the running configuration file.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Enable Fast PoE on the copper port:

    poe fast-poe-enable [port {sub-port]][,...][slot/all][all]}]

  3. Save the configuration file:

    save config

Variable Definitions

The following table defines parameters for the fast-poe-enable command.

Variable

Value

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Specifies the port or ports to be configured.