Configure Auto-sense to Create All Learned Tunnels in the Remote Area

About this task

Note

Note

You can only use this procedure on a switch with boundary-node abilities.

Perform this procedure to create all ExtremeCloud SD-WAN learned tunnels in the IS-IS remote area.

By default, Auto-sense creates SD-WAN logical interfaces in the home area.

Procedure

  1. In the navigation pane, expand Configuration > Fabric.
  2. Select AutoSense.
  3. Select the SD-WAN tab.
  4. Select remote.
  5. Select Apply.

SD-WAN Field Descriptions

Use the data in the following table to use the SD-WAN tab.

Name Description
SD-WAN Area
Note: This field only displays on a switch with boundary-node abilities.

Specifies the IS-IS area, home or remote, where Auto-sense creates all ExtremeCloud SD-WAN learned tunnels. By default, Auto-sense creates SD-WAN logical interfaces in the home area.

You can also configure exceptions for specific tunnels. For more information, see Configure the IS-IS Area for a Specific Tunnel.
Sd-Wan Vrf

Specifies the VRF name that Auto-sense uses for the SD-WAN configuration. On models that support a single active VRF, Auto-sense cannot create the dynamic SD-WAN VRF if an IP configuration already exists.

9039040-00 Rev AB