Shows the results of executing the autoexec script.
This command has no arguments or variables.
N/A
Use this command to show results when a autoexec.xsf file is executed. The file is not executed when a default.xsf file has been executed.
The CLI script file autoexec.xsf is executed after the configuration has been loaded. Its purpose is to run some commands after every reboot. It can also be used to revert to the original configuration following changes made by UPM executed persistent commands.
This command shows the results of executing the autoexec script:
show script output autoexec
When there is no autoexec.xsf file, there is no response.
This command was first available in ExtremeXOS 12.1.
This command is available on all Universal switches supported in this document.