password create-user
Configure multiple users in each role based on their user names. You can configure the
following roles: administrator, security, auditor, operator, privilege. An administrator
role also exists, but only one administrator can exist, and is the user who can configure
user access.
Note
You can only access this command after you enable enhanced secure mode using the boot
config flags enhancedsecure-mode command.
Syntax
-
password create-user
auditor WORD<1-255>
-
password create-user
operator WORD<1-255>
-
password create-user
privilege WORD<1-255>
-
password create-user
security WORD<1-255>
Command Parameters
- {auditor | operator | privilege | security}
- The administrator is the highest
level, and has access to all of the configurations and show commands, can view the
log file and security commands. Only one administrator can exists for the system.
- The privilege level has access to
all of the commands the administrator has access to, and is known as the
emergency-admin. A user at the privilege level always has to be authenticated
within the switch locally, with no RADIUS or TACACS+ authentication allowed. The
privilege level must login to the switch through the console port only.
- The operator level has access to
all configurations for packet forwarding on Layer 2 and Layer 3, and has access to
show commands to view the configuration, but cannot view the audit logs access
security, or password commands.
- The security level has access only
to security settings and can view configurations.
- The auditor can view log files,
and can view all configurations, but password configurations.
- WORD<1-255>
- Specifies the user name of the
person to connect a particular user role level with a username.
Command Mode
Global Configuration
