mlt

Configure MultiLink Trunking (MLT) to set up MLTs on the switch.

Syntax

mlt <1-512> [enable] [encapsulation dot1q] [name WORD<0-64>] [private-vlan {isolated|promiscuous|trunk}] [vlan <1-4059>]
no mlt <1-512> [enable] [encapsulation dot1q] [name] [private-vlan] [vlan <1-4059>]

<1-512>: Specifies the MLT ID in the range of 1-512.
enable: Creates and enables a new MLT.
encapsulation dot1q: Sets encapsulation. dot1q enables trunking on the MLT.
name <0-64>: Configures the name for this MLT.
private-vlan {isolated|promiscuous|trunk}: Specifies the private VLAN port type for this MLT.
vlan <1-4059>: Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

None

Global Configuration

You cannot configure an MLT name that uses all numbers, for example, 222.