show ip interface

Shows the IP configuration for an interface.

This command displays only primary IP interfaces. To view output that includes secondary IP interfaces, use the show ip address command.

Syntax

show ip interface [vrf WORD<1-16>] [vrfids WORD<0-512>]
show ip interface gigabitethernet [<1-4059>] [{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}]

Command Parameters

gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

a single slot and port (slot/port)
a range of slots and ports (slot/port-slot/port)
a series of slots and ports (slot/port,slot/port,slot/port)
all ports on the same slot (slot/all)
all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

<1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf WORD<1-16>: Specifies the name of the VRF.
vrfids WORD <0-512>: Specifies the VRF ID.

Default

None

Command Mode

User EXEC

Command Output

The show ip interface command displays the following information:


Output field	Description
INTERFACE	Indicates the slot and port.
IP ADDRESS	Indicates the IP address.
NET MASK	Indicates a subnet mask of an IP address.
ADMIN STATUS	Indicates if the IP interface is administratively enabled or disabled.
OPER STATE	Indicates if the IP interface is operationally up or down.
VLAN ID	Indicates the VLAN ID associated with this IP interface.
BROUTER PORT	Indicates whether the port is a brouter port or a routeable VLAN.
IPSEC STATE	Indicates whether the IPsec policy is enabled on the interface.
IP NAME	Indicates the IP name given to the IP address.

Example

The following example displays the command output.

Switch:1>show ip interface
==========================================================================================
                          IP Interface - GlobalRouter
==========================================================================================
INTERFACE  IP            NET            ADMIN     OPER    VLAN  BROUTER   IPSEC   IP      
           ADDRESS       MASK           STATUS    STATE   ID    PORT      STATE   NAME    
------------------------------------------------------------------------------------------
Port1/2    192.0.2.1     255.255.255.0  enable    up      20    true      disable         
Vlan10     198.51.100.0  255.255.255.0  disable   down    10    false     disable         

All 2 out of 2 Total Num of IP interfaces displayed