ip ospf hello-interval (for a port)

Syntax

• default ip ospf hello-interval

• ip ospf hello-interval <1-65535>

• ip ospf port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} hello-interval <1-65535>

Command Parameters

<1-65535>

Specifies the Hello interval range in seconds. Dead Interval must be a multiple of Hello Interval.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default is 10.

Command Mode

GigabitEthernet Interface Configuration