View topology message status to view the interconnections between Layer 2 devices in a network.
show autotopology nmm-table
None
User EXEC
The show autotopology nmm-table command displays the following information:
|
Output field |
Description |
|---|---|
|
Local Port |
Specifies the slot and port that received the topology message. |
|
IpAddress |
Specifies the IP address of the sender of the topology message. |
|
SegmentId |
Specifies the segment identifier of the segment from which the remote agent sent the topology message. This value is extracted from the message. |
|
MacAddress |
Specifies the MAC address of the sender of the topology message. |
|
ChassisType |
Specifies the chassis type of the device that sent the topology message. |
|
BT |
Specifies the backplane type of the device that sent the topology message. The switch uses a backplane type of 12. |
|
LS |
Indicates if the sender of the topology message is on the same Ethernet segment as the reporting agent. |
|
CS |
Specifies the current state of the sender of the topology message. The choices are
|
|
Rem Port |
Specifies the slot and port that sent the topology message. |
The following example displays the topology message status.
Switch:1(config)#show autotopology nmm-table
==========================================================================================
Topology Table
==========================================================================================
Local Rem
Port IpAddress SegmentId MacAddress ChassisType BT LS CS Port
------------------------------------------------------------------------------------------
0/0 192.0.2.81 0x000000 0030ab707a00 ChassisType 1 12 Yes HtBt 0/0
1/1 192.0.2.81 0x000000 0050ea268800 ChassisType 2 12 Yes HtBt 1/12
1/24 192.0.2.81 0x000000 070ab307aa00 ChassisType 3 12 Yes HtBt 1/1
2/1 192.0.2.81 0x000000 0030ab57ab00 ChassisType 4 12 Yes HtBt 1/23
2/2 192.0.2.81 0x000000 0030ab307af0 ChassisType 5 12 Yes HtBt 1/12