show lacp

View Link Aggregation Control Protocol (LACP) configuration information to determine the LACP parameters and to ensure your configuration is correct.

Syntax

Command Parameters

actor-admin
Shows LACP actor administrative information for all interfaces.
actor-oper
Shows all LACP actor operational information for all interfaces.
extension
Show all LACP timer information.
interface
Shows all LACP port configuration information for all interfaces.
interface mlt <64-6399>
Shows the MLT LACP information for all MLTs or the specific MLT index.
interface mlt id <1-512>
Specifies the MLT ID.
partner-admin
Shows all LACP partner adminstrative information.
partner-oper
Shows all LACP partner operational information.
vid <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

{slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

  • a single slot and port (slot/port)

  • a range of slots and ports (slot/port-slot/port)

  • a series of slots and ports (slot/port,slot/port,slot/port)

  • all ports on the same slot (slot/all)

  • all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

None

Command Mode

User EXEC

9039033-00 Rev AA