Configuring Wide Key ACL Modes
To configure the TCAM width of a slot, switch in a SummitStack or stand-alone switch, use the following command:
configure access-list width [double | single] [slot slotNo | all]
You must reboot for the configuration to take effect.
If you attempt to configure a double wide mode on a slot or switch that does not support it, an error message is displayed.
-
Configurations that have less that one-half the number of ACL rules that the single wide key mode supports, reboot successfully.
-
Configurations that have more than one-half the number of ACL rules that the single wide key mode supports, fail after the reboot.
-
Configurations that do not use the additional condition combinations that double wide key mode offers, reboot successfully.
-
Configurations that use the additional condition combinations that the double wide key mode offers, fail after the reboot.
To display the wide key mode settings, use the following command:
show access-list width [slot slotNo | all]