Extreme Networks

Request Demo

ExtremeXOS 16.2 User Guide > BGP > Configuring BGP > Configuring BGP Neighbors > Configure Route Flap Dampening

Published August 2016prev | next

Print this page Print this page

Email this topic

Leave feedback Feedback

Configure Route Flap Dampening

You can supply the dampening configuration parameters directly through a command line interface (CLI) command, or use the command to associate a policy that contains the desired parameters.

To enable route flap dampening for neighbors or a peer group, use the following commands:

configure bgp neighbor [all | remoteaddr] {address-family [ipv4-unicast | ipv4-multicast | ipv6-unicast | ipv6-multicast | vpnv4]} dampening {{half-life half-life-minutes {reuse-limit reuse-limit-number suppress-limit suppress-limit-number max-suppress max-suppress-minutes} | policy-filter [policy-name | none]}

configure bgp peer-group peer-group-name {address-family [ipv4-unicast | ipv4-multicast | ipv6-unicast | ipv6-multicast | vpnv4]} dampening {{half-life half-life-minutes {reuse-limit reuse-limit-number suppress-limit suppress-limit-number max-suppress max-suppress-minutes} | policy-filter [policy-name | none]}
To disable route flap dampening for a BGP neighbor or peer group, use the following commands:

configure bgp neighbor [remoteaddr | all] {address-family [ipv4-unicast | ipv4-multicast | ipv6-unicast | ipv6-multicast | vpnv4]} no-dampening

configure bgp peer-group peer-group-name {address-family [ipv4-unicast | ipv4-multicast | ipv6-unicast | ipv6-multicast | vpnv4]} no-dampening

Note

When you disable dampening, all the configured dampening parameters are deleted.

Published August 2016prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback