VR Configuration Context

Each VR and VRF has its own configuration domain or context, in which you can enter commands to configure that VR. Some commands allow you to specify a VR to which the command applies.

For other commands, you must change context to that of the target VR or VRF before you execute the command. The current context is indicated in the command line interface (CLI) prompt by the name of the user VR or VRF. If no name appears in the prompt, the context is VR-Default.

For instructions on changing context, see Changing the VR Context.

Commands that apply to the current VR context include all the BGP (Border Gateway Protocol), OSPF (Open Shortest Path First), Open Shortest Path First version 3, PIM, IS-IS, RIP (Routing Information Protocol), and RIPng (Routing Information Protocol Next Genreation) commands, and the commands listed in the following table. Commands that apply to the current VRF context are limited to BGP commands and the commands listed in the following table.

Click to expand in new window

Virtual Router Commands

[enable | disable] ipforwarding
clear iparp

1

clear counters iparp
configure iparp
configure iparp [add | delete]
[enable | disable] iparp
show iparp
configure iproute [add | delete]
show iproute
show ipstats
rtlookup
create [vlan | vman] vlan-name
[enable | disable] igmp
[enable | disable] igmp snooping
[enable | disable] ipmcforwarding
show igmp
show igmp snooping
show igmp group
show igmp snooping cache

1 Other commands are available with these listed.