New topicconfigure fdb vlan vxlan

configure fdb { mac_addr | broadcast | unknown-unicast | unknown-multicast } vlan vlan_name [ add | delete ] vxlan { vr vr_name } {ipaddress} remote_ipaddress

Description

This command allows you to add or remove remote VTEPs to a MAC address.

Syntax Description

mac_addr Forwarding destination(s) for this MAC.
broadcast Forwarding destination(s) for broadcast traffic.
unknown-unicast Forwarding destination(s) for unknown unicast traffic.
unknown-multicast Forwarding destination(s) for unknown multicast traffic.
add Add to configuration.
delete Delete from configuration.
vr VR/VRF instance the IPv4 address is configured on.
vr_name An existing VR/VRF name.
ipaddress Configure the IP address of the remote tunnel endpoint to which the MAC needs to be bound.
remote_ipaddress IPv4 address of the remote tunnel endpoint.

Default

VR-Default.

Usage Guidelines

You must first use the “[create | delete] fdb” command to add the first remote VTEP, and then issue this command to add additional remote VTEPs for the same MAC. You cannot add a remote VTEP to a static entry that has ports or blackhole configured. When the last VTEP is deleted, ExtremeXOS deletes the FDB entry for that MAC.

Example

configure fdb 01:00:5e:00:00:01 vlan vlan101 add vxlan ipaddress 30.30.30.1
configure fdb broadcast vlan vlan101 add vxlan vr VR-Default ipaddress 30.30.30.1
configure fdb unknown-unicast vlan vlan101 delete vxlan ipaddress 20.20.20.1

History

This command was first available in ExtremeXOS 21.1.

Platform Availability

This command is supported on the Summit X770, X670-G2 standalone, and stacks with X770 and X670-G2 slots only.