enable ip-fix ports

enable ip-fix ports [port_list | all] {ipv4 | ipv6 | non-ip | all_traffic}

Description

Enables IPFIX on the ports.

Syntax Description

port_list

Specifies the ports.

all

Specifies all ports.

ipv4

Meter IPv4 traffic.

ipv6

Meter IPv6 traffic.

non-ip

Meter non-IP layer 2 traffic.

all_traffic

Meter IPv4, IPv6, and non-IP traffic. This is the default.

Default

The default is disabled. When enabled, the default is all_traffic.

Usage Guidelines

In addition to enabling IPFIX support of the port, use this command to check that the port being enabled has hardware support for IPFIX.

If the port does not support IPFIX, an error message similar to the following is displayed:

Error: IPFIX is not supported by hardware on port <slot>:<port>

The port specified must be either a physical port that is not part of a trunk LAG, or it must be the LAG master port. When it is neither of these, the following message is displayed:

Error: Master port 3:1 is enabled for IPFIX but Member port 5:2 is not capable.

When the specified port is the LAG master port, all ports in that LAG must support the IPFIX feature in hardware. If one or more ports in the LAG do not support IPFIX, the following error message is displayed:

Error: IPFIX is not supported on port 5:1.

Example

The following command enables IPFIX metering of IPv6 traffic on port 2:1:

enable ip-fix ipv6 ports 2:1

History

This command was first available in ExtremeXOS 12.5.

Platform Availability

This command is available on all platforms.