Port Policing

This page allows you to configure the Policer settings for all switch ports.

Click to expand in new window
../Graphics/config_qos_port_policers.png
Object Description
Port The port number for which the configuration below applies.
Enabled Controls whether the policer is enabled on this switch port.
Rate Controls the rate for the policer. The default value is 500. This value is restricted to 100 – 1000000 when the “Unit” is “kbps” or “fps”, and it is restricted to 1 – 3300 when the “Unit” is “Mbps” or “kfps”.
Unit Controls the unit of measure for the policer rate as kbps, Mbps, fps or kfps . The default value is “kbps”.
Flow Control If flow control is enabled and the port is in flow control mode, then pause frames are sent instead of discarding frames.
Buttons
../_Common/../Graphics/save_new.png Save changes.
../_Common/../Graphics/reset_new.png Undo any changes and revert to previously saved values.