Configuring ERPS on Switch 2 (RPL Neighbor)

  1. From the web browser, navigate to Configuration > ERPS.
  2. Click Add New Protection Group and configure the ERPS (Ethernet Ring Protection Switching) as shown below.
    Click to expand in new window
    ERPS 1 on Switch 2
    ../Graphics/erps-sw2-erps-create.png
  3. Edit ERPS1 by clicking 1 under the ERPS ID column.
  4. Set the configuration as follows:
    1. Set the RPL Role to RPL_Neighbour on Port0.
    2. Click the VLAN Config link in the Instance Configuration table to add or edit the protected VLAN (Virtual LAN) (VLAN ID = 1).
      Click to expand in new window
      Adding the Protected VLAN
      ../Graphics/config_erps_vlan_s1_new.png
    3. Click ../Graphics/save_small.png.
    Click to expand in new window
    Configuring ERPS 1
    ../Graphics/erps-sw2-erps-config.png
  5. Click ../Graphics/save_small.png.