=================================================================================== REVISION NOTES FOR BAYRS VERSION 14.20 REVISION 12 BASED ON 14.20 REVISION 11 =================================================================================== Site Manager compatibility: BayRS version is managed by Site Manager version 14.20 Rev. 12 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 11 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 10 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 9 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 8 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 7 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 6 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 5 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 3 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 2 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 1 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 -------> 14.20, 14.20 Revisions 1,2 and 6 =================================================================== BayRS and BCC Version 14.20 Revision 12 corrects the following problems: =================================================================== Q00564444-02: PP5430_Quad_Serial The Quad serial module on the PP5430 router corrupts packets. A new processor board is needed to resolve this issue. It is available with ECO E402199. Q00517502-01: FT1 Request to allow the ability to turn off FDL (Facilities Data Link) functionality on the FT-1. Q00493592-03: PP5430 FT-1 SDB modules in a PP5430 router may fail online hardware diagnostics after the router experiences a watchdog fault. The PP5430 Diags v1.16 needs to be loaded to resolve this issue. Q00494678: PP5430 A watchdog fault may occur on a PP5430 router when passing small frame IP traffic. Q00494691: PP5430 The PP5430 diagnostic tests intermittently read the FE-1 SDB ID as an ISDN and subsequently fails or hangs the router. This is a software change that compliments the change in the PP5430 V1.16 Diags. Q00503441: PP5430 Enable the hardware monitor in the Prom code. Q00519028: PP5430 A defective FT1 module may cause a hang when running diagnostic tests on a PP5430 router. The PP5430 Diags v1.16 needs to be loaded to resolve this issue. =================================================================== BayRS and BCC Version 14.20 Revision 11 corrects the following problem: =================================================================== Q00490342-01: ARP The BayRS router will fault if an ethernet interface is configured with ARPINARP and host cache aging. ================================================================ REVISION NOTES FOR BAYRS VERSION 14.20 REVISION 10 ================================================================ Site Manager compatibility: BayRS version is managed by Site Manager version 14.20 Rev. 10 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 9 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 8 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 7 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 6 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 5 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 3 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 2 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 1 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 -------> 14.20, 14.20 Revisions 1,2 and 6 =================================================================== BayRS and BCC Version 14.20 Revision 10 corrects the following problems: =================================================================== Q00043578-03: OSPF A bus error may occur in OSPF while LSDB entries are being updated. Q00048239-02: OSPF A bus error may occur in an unstable network where OSPF is continuously bouncing. Q00072480-03: OSPF A fault may occur after the OSPF soloist switches to another slot. Q00080635: IP Traffic Filters When a Forward-to-Next-Hop traffic filter is configured on a router interface, a bus error may occur when traffic is received on that interface. Q00088344-02: ARP There is a delay of up to 11 seconds for an ARP request to be sent out from the router after an ARP entry has been removed from the ARP cache. This delay can result in connectivity problems. Q00208316: Protocol Priority Outbound filters will not work when bandwidth on demand has been configured on an ISDN PPP circuit which also has protocol priority configured. Q00218273-04: PP2430 The console port locks up on a PP2430 when a sync interface changes state. Q00305630-03: TI Tag violation faults and memory corruption can occur when TI initializes. Q00461358-02: PP2430 when a Xircom PCMCIA modem is used as the console port the modem will answer but occasionally will not send the login prompt. Occasionally this will result in a router fault within a few minutes. Q00484079-03: PP2430 Repeated dialing into a PP2430 to open and close a TI session will eventually cause the router to fault. ================================================================ REVISION NOTES FOR BAYRS VERSION 14.20 REVISION 9 ================================================================ Site Manager compatibility: BayRS version is managed by Site Manager version 14.20 Rev. 9 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 8 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 7 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 6 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 5 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 3 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 2 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 1 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 -------> 14.20, 14.20 Revisions 1,2 and 6 =================================================================== BayRS and BCC Version 14.20 Revision 9 corrects the following problem: =================================================================== Q00065702-03: DLSw DLSw may fail to send test polls to the FEP after a line card is replaced by the Telco. ================================================================ REVISION NOTES FOR BAYRS VERSION 14.20 REVISION 8 ================================================================ Site Manager compatibility: BayRS version is managed by Site Manager version 14.20 Rev. 8 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 7 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 6 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 5 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 3 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 2 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 1 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 -------> 14.20, 14.20 Revisions 1,2 and 6 ================================================================== BayRS and BCC Version 14.20 Revision 8 corrects the following problems: ================================================================== Q00391307-01: Radius When Radius is enabled, if an invalid login attempt is made, the router logs a message that an invalid radius access response packet was received and disables the Radius server rather than sending an access reject packet. Q00413482-02: SNMP When an SNMP get request packet is received with an incorrect checksum and also has both the More bit and Do Not Fragment bit set, the router may fault. Q00245641-04: TI_INIT The TI_INIT process does not release memory on FRE4 and ARE modules when the Serial Port ModemEnable attribute is enabled. If many login requests are made, this could eventually cause an out of memory fault on the router. ================================================================ REVISION NOTES FOR BAYRS VERSION 14.20 REVISION 7 ================================================================ Site Manager compatibility: BayRS version is managed by Site Manager version 14.20 Rev. 7 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 6 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 5 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 3 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 2 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 1 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 -------> 14.20, 14.20 Revisions 1,2 and 6 ================================================================== BayRS and BCC Version 14.20 Revision 7 corrects the following problems: ================================================================== Q00259789-07: SNMP Running the SNMP Certs test suite will cause an out of memory fault on the ARE module on the BN router. Q00302720-04: SNMP When an SNMP request that has 1270 bytes or more of data is received on an ARN or AN router that has the buffer size set to 1824 (default), the router will fault or hang. Q00317176-05: SNMP When an SNMP request packet that contains an SNMP community length field that is greater than the size of the packet is received on an ATM interface on a BN router, the router will fault. Q00286620-04: Radius When the router receives incorrectly formatted Radius Authentication packets (i.e. the packet size is less than the minimum or greater than the maximum size, or contains an incorrectly formatted vendor specific attribute) the router will fault. ================================================================ REVISION NOTES FOR BAYRS VERSION 14.20 REVISION 6 ================================================================ Site Manager compatibility: BayRS version is managed by Site Manager version 14.20 Rev. 6 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 5 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 3 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 2 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 Rev. 1 -------> 14.20, 14.20 Revisions 1,2 and 6 14.20 -------> 14.20, 14.20 Revisions 1,2 and 6 =================================================================== BayRS and BCC Version 14.20 Revision 6 corrects the following problems: =================================================================== Q00247420-07: SNMP The router will fault when an SNMP request packet is received that contains a community string that is greater than 256 characters in length. Q00248132-08: SNMP The router will fault when an SNMP request packet is received that contains a variable length field value that is greater than the actual size of the data.