Replacing a Summit 750 W AC Power Supply

The Summit 750 W AC power supply is compatible with the Summit X460 series PoE (Power over Ethernet)-capable switches.

You need the following tools and materials to replace a Summit 750 W AC power supply:

These switches have two bays for hot-swappable power supplies. In a switch with a redundant power configuration, you can replace one Summit AC power supply without powering down the switch.

To replace a Summit 750 W AC power supply, follow these steps:

  1. Disconnect the AC power cord from the wall outlet and from the power supply.
  2. Note the orientation of the installed power supply.
  3. Push the latching tab toward the power supply handle and pull outward on the handle to disengage the power supply internal connectors.
    See Removing a Summit 750 W AC Power Supply.
    Click to expand in new window
    Removing a Summit 750 W AC Power Supply
    ../Graphics/SH_206_X460_Remove_PoE_PSU.svg
  4. Carefully slide the power supply the rest of the way out of the switch.
    Caution

    Caution

    Power supplies can become very hot during operation. Wear thermal protective gloves when you remove a power supply from an operating switch.
    Note

    Note

    If you are not installing a replacement power supply, install a cover over the unoccupied power supply bay. Unoccupied bays must always be covered to maintain proper system ventilation and EMI levels.
  5. Verify that the replacement power supply is oriented the same way as the unit you removed.
  6. Carefully slide the power supply all the way into the power supply bay.
    See Installing a Summit 750 W AC Power Supply.
    Click to expand in new window
    Installing a Summit 750 W AC Power Supply
    ../Graphics/SH_205_X460_Install_PoE_PSU.svg
  7. Push the power supply in until the latch snaps into place.
    Caution

    Caution

    Do not slam the power supply into the switch.
  8. If necessary, slide the plastic cord retainer farther away from the back of the switch.
    See Moving the Power Cord Retainer.
    Click to expand in new window
    Moving the Power Cord Retainer
    ../Graphics/SH_227_move_clamp.svg
  9. Connect the AC power cord to the input connector.
    See Connecting the Power Cord.
    Click to expand in new window
    Connecting the Power Cord
    ../Graphics/SH_228_connect_750WAC.svg
  10. Open the clip and slip it over the barrel of the connector.
    See Attaching the Power Cord Retainer.
    Click to expand in new window
    Attaching the Power Cord Retainer
    ../Graphics/SH_229_750W_retainer.svg
  11. Snap the clip firmly around the connector.
  12. Connect the other end of the power cord to an AC power outlet.