Replacing an XGM3/XGM3S Series Port Option Card in a Summit X460 Series Switch

Note

Note

After you replace an XGM3-2sf port option card, you must reboot the switch before the ports on the card will become operational.

To replace an XGM3/XGM3S series port option card:

  1. Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate ground point on the rack.
  2. Loosen the captive retaining screws on the option card until they are completely loose (see Removing an XGM3-2sf Port Option Card).
  3. Carefully slide the option card out of the slot.
    Click to expand in new window
    Removing an XGM3-2sf Port Option Card
    ../Graphics/SH_215_Remove_XGM3.svg
  4. Carefully slide the replacement option card into the switch.
    Click to expand in new window
    Installing an XGM3-2sf Port Option Card
    ../Graphics/SH_214_Install_XGM3.svg
  5. Align and tighten the captive retaining screws.