Installing an STK-RPS-150PS in an RPS Shelf

Caution

Caution

Observe all ESD (electrostatic discharge) precautions when handling sensitive electronic equipment.

On the STK-RPS-150CH8 shelf, a cover plate will be in place over each power-supply slot.

To install the power supplies:

  1. Place the RPS shelf on a sturdy flat surface where you plan to install power supplies.
  2. Align the power supply with one of the slots, then slide the power supply forward until its front panel is flush against the RPS shelf front panel.
    Click to expand in new window
    STK-RPS-150PS Installation in an STK-RPS-150CH2 Shelf
    ../Graphics/Install_rps_150_ch2.svg
    1 = STK-RPS-150CH2 shelf 3 = Shelf power supply slot
    2 = STK-RPS-150PS power supply 4 = Captive screws (2)
    Click to expand in new window
    STK-RPS-150PS Installation in an STK-RPS-150CH8 Shelf
    ../Graphics/Install_rps_150_ch8.svg
    1 = STK-RPS-150CH8 shelf 3 = Captive screws (2)
    2 = STK-RPS-150PS power supply 4 = Shelf power supply slot
  3. Fasten the power supply to the RPS shelf using the captive screws on the PSM front panel.
  4. Repeat the two previous steps for each additional power supply.
  5. Proceed to Installing the RPS Shelf into the Rack.