Installing the EPS-160 Power Supply into an EPS-T

To install an EPS-160 power supply into the EPS-T, follow these steps:

  1. Remove the EPS-160 power supply from the packing material.
  2. Remove the cover plate from an empty slot on the EPS-T.
  3. Insert the power supply into the empty slot on the EPS-T.
  4. Tighten the captive thumbscrews to secure the power supply to the EPS-T.

Connect the EPS-160 power supply to the Summit switch, following the instructions in Connecting the EPS-160 Power Supply to the Switch.