Installing a Summit X650 Switch in a Rack

Before you begin the installation, refer to Pre-installation Requirements.

The Summit X650 series switch fits into a standard 19-inch equipment rack.

The provided rack-mounting brackets attach to the front of the switch unit and are adaptable to either a front-mount or mid-mount installation. Optional rear-mounting brackets are also included for four-post racks or cabinets.

  1. On one side of the switch, set a mounting bracket against the switch housing.
    To mid-mount the switch, set the flange toward the back of the switch.
    To front-mount the switch, set the flange even with the front panel of the switch.
    To mount the switch on a four-point rack or in a cabinet, set the flange even with the front panel of the switch.
  2. Use six of the provided screws to secure the bracket to the switch housing.
  3. Repeat the previous two steps to attach the other bracket to the other side of the switch.
  4. Slide the switch into the equipment rack.
  5. Secure the mounting bracket flanges to the rack, using screws that are appropriate for the rack.

    (Rack-mounting screws are not provided.)

  6. If you are mounting the switch in a four-post rack or a cabinet, secure the rear mounting brackets.
    1. At the rear of the rack or cabinet, for each side, slide the rear mounting brackets (rails) between the two rows of pegs on either side of the switch.
    2. Secure the rear mounting brackets to the rack posts using suitable screws. Be sure that the switch is level.
      See Attaching a Rear Mounting Bracket.
      Click to expand in new window
      Attaching a Rear Mounting Bracket
    3. Securely tighten the rack mounting screws, as shown in Fastening the Rear Mounting Brackets.
      Click to expand in new window
      Fastening the Rear Mounting Brackets

To install optional pluggable transceivers, such as SFP and SFP+ optical devices, refer to the installation instructions in the Extreme Networks Pluggable Transceivers Installation Guide.

Summit X650 series switches are shipped without installed power supplies. You can install one or two 850W AC or DC power supplies.

After the switch is secured to the rack, install the necessary power supplies for your configuration. Follow the instructions in Installing an 850 W Internal AC Power Supply or Installing an 850 W Internal DC Power Supply.