Install the Access Point to a Wall with AH-ACC-BKT-AX-WL

Before you begin

You need the following items:
  • AP5020
  • Three M3.5 screws and three screw-in anchors, shipped with the -WL bracket
  • One AH-ACC-BKT-AX-WL bracket

About this task

Use the AH-ACC-BKT-AX-WL bracket when you need a 1.25 inch space between the wall and the access point. If you want less space, use the AH-ACC-BKT-AX-TB that comes with the AP.

Procedure

  1. Using the -WL bracket as a template, mark and drill mounting holes on the wall.
  2. Bring the LAN cable from the wall through the bracket hole.
    Align the cable before attaching the bracket to the wall.
    Note

    Note

    A standard Ethernet cable can be used if you do not mind the cable being visible. To hide the Ethernet cable, a flat cable and a cable cap are required.
  3. Attach the wall bracket to the wall using three M3.5 screws and three screw-in anchors.
  4. Align the access point red dot against the three red dots on the -WL bracket.
  5. Press and rotate the access point clockwise about one-sixth turn until it locks into place on the bracket.
  6. Attach the network cable.
9037977-00  Rev AA