The following are new open issues for supported features found in ExtremeXOS 30.6.1-Patch1-2.
| CR Number | Description |
|---|---|
| General | |
| xos0078188 | Image installation takes a little longer for ExtremeXOS 30.6, and the following
log message might appear due to
this:<Warn:EPM.Upgrade.State> Upgrade status Installation time may be greater than expected due to a lack of memory resources |
| Extended Edge Switching | |
| xos0077857 | With a one-armed and cross-connect MLAGs in a ring topology, link flap of 1 to 2 minutes on the ISC ports causes the ring to remain in the severed state. |
| xos0078375 |
With a large amount of multicast traffic on an Extended Edge Switching ring with controlling bridge (CB) MLAG setup, traffic loss and duplicates occur after rebooting a CB. Workaround: Change the IPMC replication mode to the CB using the following command: configure forwarding vpex ipmc replication controlling-bridge. |
| ExtremeSwitching X695 Series Switches | |
| xos0077787 | On ExtremeSwitching X695 series switches, clearing the port counters when running the show port statistics command causes the console to stop responding for a few seconds. |
| xos0077548 | On ExtremeSwitching X695 series switches, "Other" group CPU utilization does not appear accurately in the show process group command. |
| xos0077557 | On ExtremeSwitching X695 series switches, the command show process group displays CPU utilization of the "Other" group tasks also under the "EXOS" group. |
| xos0077760 | On ExtremeSwitching X695 series switches, IPv6 tunnel traffic might be dropped at the tunnel end point when multiple IPv6-to-IPv4 and IPv6-in-IPv4 tunnels are configured. |
| xos0078223 | On ExtremeSwitching X695 series switches, IP/TCP fragment anomaly protection counters do not increment appropriately. |
| xos0077836 | On ExtremeSwitching X695 series switches, with ECMP enabled for the VXLAN overlay network, deleting static overlay routes produces a shadow problem error and traffic is stopped. |
| xos0077730 | On ExtremeSwitching X695 series switches, VMAN over VXLAN is not supported. |