Apply a WIPS policy to the Network Policy

Ensure you have completed the following procedures in sequence:

Log in and Select the Network Policy
Configure the AP Template

Note

The following steps are examples for AP models that only support radio-share sensor mode, each radio interface is currently pre-selected. For any radio-share sensor model AP, the only configuration needed to have the AP operate in radio-share sensor mode is to create and apply a WIPS policy to the Network Policy.

Perform these steps to apply a WIPS policy to the network policy.

From the WIRELESS → Configuration Settings → Application Management navigation list, select WIPS.
Select WIPS and toggle it ON.
Select the Name field and enter a name for the WIPS policy.
Select Enable AirDefense Essentials and toggle it ON.
Select Save to confirm the changes.

Note

You have created and applied the WIPS policy to the Network Policy. The AP is now ready to be updated with new Network Policy settings.

Continue to the next procedure in the series, Deploy the Policy.