Interfaces

Device Details for Interfaces

When you select the host name of an AP from the Devices list and then select Monitor > Monitoring > Wireless Interfaces or Wired Interfaces, the following information is displayed (APs only):

At the top of the Wireless main section, you can adjust the time range by Day, Week, or Month, and for 1, 2, 4, 8, and 24 hour durations to view the Wi-fi channel utilization.
Within the Wi-fi Health table, view the overall, SNR, channel utilization, and association per radio scores for 2.4 GHz, 5 GHz, 6GHz, and combined.
The Total Clients, Clients with Poor Health, Surrounding BBSSIDs, CPU Usage, and Memory Usage are also displayed with tables for more specific details pertaining to channel utilization and wi-fi.
The Surround Access Points table at the bottom of the page, displays the following columns:
- MAC (BSSID)
- SSID
- Channel Width (MHz)
- RSSI
- Mode
- Rogue AP / Friendly AP
- Extreme Networks Device
- CU (%)
- CRC
- # Clients

At the top of the Wired main section, you can adjust the time range by Day, Week, or Month, and for 1, 2, 4, 8, and 24 hour durations to view CPU Usage, Memory Usage, Connected Clients, TX Bytes, RX Bytes, TX Errors, RX Errors, Discards TX, and Discards RX.
The Total Clients and Number of Ports in Use are also displayed.
The Interface Details table at the bottom of the page, displays the following columns by default:
- Status
- Interface
- Port Type
- Connected Clients
- Speed
- TX Bytes
- RX Bytes
- TX Errors
- RX Errors
- TX Drops
- RX Drops
Select the column picker to add additional columns or hide default columns:
- LLDP Port #
- LLDP Sys-ID
- LLDP Sys-Name

When you select the host name of a switch from the Devices list and then select Monitor > Monitoring > Interfaces , the following information is displayed (Switches only):

At the top of the main section, CPU Usage, Memory Usage, MAC Table Utilization, Last Seen time, Temperature, Power Supply Status, Fan Status, IP Address, MAC Address, Software Version, Device Model, Serial Number, Make, and IQAgent Version are all listed.
The graphic below shows all of the ports on the device. Selecting a port displays more information.
Within the VLAN tab are the VLAN Name, VLAN ID, Active Ports (Enabled port with VLAN assigned), STP Instance, IGMP Snooping, and DHCP Snooping information columns. Selecting a VLAN within the VLAN tab highlights the ports that are currently assigned.
Within the IPv4 tab the VLAN Name, VLAN ID, IPv4 Forwarding, Routing Instance, and IP Address / Subnet information columns are displayed. The VLAN can be selected when the row is highlighted. Ports using the VLAN, both tagged and untagged that are actively provisioned, light up to indicate ports using the VLAN. Select a port to display the port name, port status, VLAN untagged/tagged status, and port actions.