This command lets you specify single or double-wide slices for the rules given.
| slices | Configures look-up stage TCAM resources. |
| ingress | Specifies to configure the ingress stage TCAM slice width (ACL mode only). |
| ipv4-single-only | Specifies IPv4 ACLs are installed in single-wide slices. |
| ipv4-double-only | Specifies IPv4 ACLs are installed in double-wide slices |
ipv4-single-only
The ipv4-double-only option is not available for the supported platforms.
To make changes using this command, you must first disable policy (disable policy).
The precedence of policy slices can't be changed.
The setting only applies to access-list mode.
To view selections made by this command, use the show policy slices and show policy state commands.
The following example configures policy to use IPv4-double-only slices:
# configure policy slices ingress ipv4-double-only
This command was first available in version 33.3.1.
5420, 5320, 4220, 5520, 5720, 7520, 7720 Series switches.