Configure the IS-IS Area for a Specific Tunnel

About this task

Note

You can only use this command on a switch with boundary-node abilities.

Perform this procedure to specify the IS-IS area where Auto-sense creates a specific ExtremeCloud SD-WAN-learned tunnel. This configuration overrides a global area configuration for all learned tunnels.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure the IS-IS area:
auto-sense sd-wan multi-area logical-intf-dest-ip {A.B.C.D} <home | remote>

Variable Definitions

The following table defines parameters for the auto-sense sd-wan multi-area logical-intf-dest-ip {A.B.C.D} <home | remote> command.


Variable	Value
{A.B.C.D}	Specifies the destination IP address of the SD-WAN logical interface.
<home \| remote>	Specifies the IS-IS area as home or remote. By default, Auto-sense creates SD-WAN logical interfaces in the home area.