Configuring SLPP

Enable the Simple Loop Prevention Protocol (SLPP) globally and for a VLAN to detect a loop and automatically stop it. The VLAN configuration controls the boundary of SLPP-PDU transmission.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enable SLPP:

    slpp enable

  3. Configure the transmission interval:

    slpp tx-interval <500–5000>

  4. Add a VLAN to the transmission list:

    slpp vid <1-4059>

Example

Enable SLPP:

Switch(config)# slpp enable

Configure the transmission interval to 5000 milliseconds:

Switch(config)# slpp tx-interval 5000

Add a VLAN, with the VLAN ID 2, to the transmission list:

Switch(config)# slpp vid 1

Variable Definitions

Use the data in the following table to use the slpp command.

Variable

Value

enable

Enables or disables the SLPP operation.

You must enable the SLPP operation to enable the SLPP packet transmit and receive process.

If you disable the SLPP operation, the system sends no SLPP packets and discards received SLPP packets.

To set this option to the default value, use the default operator with the command. The default is disabled.

500–5000

Configures the SLPP packet transmit interval, expressed in milliseconds in a range from 500–5000. The default value is 500. To set this option to the default value, use the default operator with the command.

<1-4059>

Adds a VLAN, by VLAN ID, to a SLPP transmission list. Use the no operator to remove this configuration.

Job aid

The following table provides SLPP values.

Table 1. SLPP values

Enable SLPP

Setting

Access SMLT

Yes

Core SMLT

No

Primary switch

Packet Rx threshold

5

Transmission interval

500 milliseconds (ms) (default)

Secondary switch

Packet Rx threshold

50

Transmission interval

500 ms (default)